Notices for Hanging Basket Suspension Mechanism

1. Installation ground should choose horizontal surface. When inclined surface is encountered, it should be padded reliably under the corner wheel. If the installation surface is a waterproof and thermal insulation layer, it should be padded with 2.5-3 cm thick wooden board under the front and rear seats to prevent damage to the waterproof and thermal insulation layer. Chinese style

The adjustable support height of adjustable suspension bracket should make the lower side of front beam slightly higher than the height of parapet wall. If possible, after the positioning of suspension mechanism, the padded wood blocks should be fixed between the lower side of the extension end of front beam and parapet wall. _

 3, the extension length of the front beam extension is 0.3~1.5 meters. When exceeding the rated overhang length, reliable reinforcement measures and rated working load must be taken. _

_4. The distance between front and rear seats should be adjusted to the maximum distance as far as possible under the permissible conditions of the site. _

5. The distance between the two supports should be adjusted to 3-5 cm shorter than the length of the suspension platform. _

6. When tightening and reinforcing the wire rope, the front beam should be slightly upward warped by 3 to 5 centimeters to produce prestressing force and improve the steel degree of the front beam. Chinese style

 7, when the wire rope is clamped, the number of rope clips is no less than 3, and the U shape opening and the end of the wire rope are opposite to the side, and the direction is the same. The rope clamp should be clamped from the lifting point in turn, and between the last rope clamp and the first rope clamp, the wire rope should be slightly arched.

Prev：Daily Maintenance and Protection of Wire Rope

Next：How to ensure maintenance of hanging basket

back